• Osiloscope NON


    TYPE : 5102P


    • Trigger mode: edge/pulse width/line selectable video/slop/overtime etc.
    • USB host and device connectivity, standard (note: USB port is NOT intended to be used to recharge cell phones
    • & other usb charged devices. )
    • Multiple automatic measurements
    • Four math functions, including FFTs standard
    • Provides software for PC real-time analysis
    • Acquisition modes: normal, peak detect, average
    • Inputs coupling: AC, DC, GND
    • Inputs impedance: 1MΩ±2% ‖ 20pF±3pF
    • Probe attenuation: 1X, 10X
    • Supported Probe Attenuation Factor: 1X, 10X, 100X, 1000X
    • Maximum input voltage: CAT I and CAT II: 300VRMS (10×), Installation Category CAT III: 150VRMS (1×) Installation
    • Category II: derate at 20dB/decade above 100kHz to 13V peak AC at 3MHz* and above. For non-sinusoidal
    • waveforms, peak value must be less than 450V. Excursion above 300V should be of less than 100ms duration.
    • RMS signal level including all DC components removed through AC coupling must be limited to 300V. If these
    • values are exceeded, damage to the oscilloscope may occur.
    • Sample rate range: 500MS/s–1GS/s
    • Waveform interpolation: (sin x)/x
    • Sample rate and delay time accuracy: ±50ppm(at over any ≥1ms time interval)
    • Position range: 20ns/div to 80us/div; (-8div x s/div) to 40ms; 200us/div to 40s/div; (-8div x s/div) to 400s
    • Rise time at BNC: 3.5ns
    • Math: +, -, *, /, FFT
    • FFT windows: Hanning, Flatop, Rectamgular, Bartlett, Blackman, 1024 sample point
    • Bandwidth limit: 20MHz
    • Low frequency response: (-3db) >≤10Hz at BNC
    • DC gain accuracy: ±3% for Normal or Average acquisition mode, 5V/div to 10mV/div; ±4% for Normal or Average
    • acquisition mode, 5mV/div to 2mV/div
    • DC measurement accuracy: When vertical displacement is zero, and N ≥16:± (3% × reading + 0.1div + 1mV) only
    • 10mV/div or greater is selected. When vertical displacement is not zero, and N≥16: ± [3% × (reading + vertical
    • position) + 1% of vertical position + 0.2div]; Add 2mV for settings from 2mV/div to 200mV/div; add 50mV for
    • settings from 200mV/div to 5V/div
    • Trigger types: Edge, Video, Pulse, Slope, Over time, Alternative
    • Trigger source: CH1, CH2, EXT, EXT/5, AC Line
    • Trigger modes: Auto, Normal, Single
    • Coupling type: DC, AC, Noise Reject, HF Reject, LF Reject
    • Holdoff range: 100ns ~ 10s
    • Readout resolution: 6 digits
    • Accuracy (typical):±30ppm (including all frequency reference errors and ±1 count errors)
    • Frequency range: AC coupled, from 4Hz minimum to rated bandwidth
    • Output voltage: About 5Vpp into ≥1MΩ load
    • Size: 385mm x 200mm x 245mm
    • Weight: 2.08kg, 4.5 lbs

    Osiloscope NON


Main Menu