BRAND : HANTEK

TYPE : 5102P

SPECIFICATIONS :

• Trigger mode: edge/pulse width/line selectable video/slop/overtime etc.
• USB host and device connectivity, standard (note: USB port is NOT intended to be used to recharge cell phones
• & other usb charged devices. )
• Multiple automatic measurements
• Four math functions, including FFTs standard
• Provides software for PC real-time analysis
• Acquisition modes: normal, peak detect, average
• Inputs coupling: AC, DC, GND
• Inputs impedance: 1MΩ±2% ‖ 20pF±3pF
• Probe attenuation: 1X, 10X
• Supported Probe Attenuation Factor: 1X, 10X, 100X, 1000X
• Maximum input voltage: CAT I and CAT II: 300VRMS (10×), Installation Category CAT III: 150VRMS (1×) Installation
• Category II: derate at 20dB/decade above 100kHz to 13V peak AC at 3MHz* and above. For non-sinusoidal
• waveforms, peak value must be less than 450V. Excursion above 300V should be of less than 100ms duration.
• RMS signal level including all DC components removed through AC coupling must be limited to 300V. If these
• values are exceeded, damage to the oscilloscope may occur.
• Sample rate range: 500MS/s–1GS/s
• Waveform interpolation: (sin x)/x
• Sample rate and delay time accuracy: ±50ppm(at over any ≥1ms time interval)
• Position range: 20ns/div to 80us/div; (-8div x s/div) to 40ms; 200us/div to 40s/div; (-8div x s/div) to 400s
• Rise time at BNC: 3.5ns
• Math: +, -, *, /, FFT
• FFT windows: Hanning, Flatop, Rectamgular, Bartlett, Blackman, 1024 sample point
• Bandwidth limit: 20MHz
• Low frequency response: (-3db) >≤10Hz at BNC
• DC gain accuracy: ±3% for Normal or Average acquisition mode, 5V/div to 10mV/div; ±4% for Normal or Average
• acquisition mode, 5mV/div to 2mV/div
• DC measurement accuracy: When vertical displacement is zero, and N ≥16:± (3% × reading + 0.1div + 1mV) only
• 10mV/div or greater is selected. When vertical displacement is not zero, and N≥16: ± [3% × (reading + vertical
• position) + 1% of vertical position + 0.2div]; Add 2mV for settings from 2mV/div to 200mV/div; add 50mV for
• settings from 200mV/div to 5V/div
• Trigger types: Edge, Video, Pulse, Slope, Over time, Alternative
• Trigger source: CH1, CH2, EXT, EXT/5, AC Line
• Trigger modes: Auto, Normal, Single
• Coupling type: DC, AC, Noise Reject, HF Reject, LF Reject
• Holdoff range: 100ns ~ 10s
• Readout resolution: 6 digits
• Accuracy (typical):±30ppm (including all frequency reference errors and ±1 count errors)
• Frequency range: AC coupled, from 4Hz minimum to rated bandwidth
• Output voltage: About 5Vpp into ≥1MΩ load
• Size: 385mm x 200mm x 245mm
• Weight: 2.08kg, 4.5 lbs